Easy Bond Spray Adhesive 500ml Snagging Cans

Fosseway Easy Bond Spray Adhesive in a convenient 500ml snagging can with variable spray nozzle. Ideal for that patch up jobs on site.

Easy-Bond is a CFC free, multipurpose spray able adhesive with low odor, developed to bond a wide variety of substrates.  It has excellent grab and a long open time.  The product is delivered through a hose and spray gun system, which means application, is clean and efficient.  After use the gun is locked off and the system remains ready for instant re-use.

Product Uses

Easy-Bond will bond a wide variety of substrates, including wood, metals, rubber, fabric, most plastics, cardboard, polythene and concrete, as well as decorative laminates.  It can also be used to bond expanded polystyrene when forming a bond to a different substrate; in this instance the product should be used as a one way stick and only applied to the opposite substrate (do not spray onto the expanded polystyrene).  It is ideal for permanent bonds that require good initial bond strength.  It provides good temperature resistance and if protected from contamination has an open time of several hours.  Always test a small sample of the materials first to ensure the suitability of the product for the application.  For instance, some vinyl’s contain large amounts of plasticizer which, over time, can migrate and soften the bond.  When in doubt, test first.

Application

USE IN A WELL VENTILATED AREA

1. Surfaces to be bonded should be clean, dry and free from dust and grease.
2. Substrates should be conditioned before assembly.  This is particularly important with laminates.  Condition for 48 hours at 20°C with a relative humidity of 45-55%.  Air should be able to circulate freely around the components.
3. Connect the hose to the canister and the spray gun to the hose and tighten the connections.
4. Open the valve on the canister.  The valve should remain open until the canister is used up.  Use the      locking nut on the gun after use.  Turning off the valve will result in the adhesive drying in the hose and gun causing blockages.
5. Hold the spray gun at 90° to the surface and apply a uniform generous coat of adhesive, ensuring 80-100% coverage.
6. Move the gun in parallel to the surface and pay particular attention to the edges.
7. Do not allow the adhesive to puddle as this can cause an unevenness that can “show” through the laminate.
8. On porous surfaces it may be necessary to apply a second coat.  Always apply to the laminate first and spray one substrate horizontally and the other vertically.
9. It is important to remember that Easy-Bond is a contact adhesive and forms its bond by sticking to itself, so there must be sufficient adhesive for this to happen.
10. Allow the adhesive to tack up and protect from contamination whilst this happens.  The adhesive is ready when it feels dry to the touch and does not transfer to the finger tips.

Note: Easy-Bond dries in two minutes under normal conditions, but this will vary under different temperatures and humidity’s.  High humidity and low temperatures will slow the drying time and if the temperature gets very low, can produce bloom.  Bloom is moisture which forms on the glue line caused by solvent evaporation lowering the air temperature above it.

You may also be interested in this/these product(s)

Easy Bond Spray Adhesive 17.5Kg Pots Price from only: £156.00

Easy Bond Spray Adhesive 17.5kg & Gun SPECIAL OFFER Price from only: £219.00